netprosto Posted March 17, 2019 Report Share Posted March 17, 2019 Hello! How I need to configure Link G4+ Evo PnP and Motec C127. I want to transmit AN6 signal from Link G4+ to C127. I made it. It's not working. What was my mistake? Thanks in advance for your reply! Link G4+ Config Motec C127 Config Quote Link to comment Share on other sites More sharing options...
Adamw Posted March 17, 2019 Report Share Posted March 17, 2019 Motec use hexidecimal notation for the CAN ID/Address, Link use decimal. Hex 384 (motec end) is decimal 900 (set at link end). Motec use the terminology "Alignment: word swap" to refer to LS byte first, so change that to normal. Uncheck the "signed" checkbox in the motec setup as you are sending from the Link unsigned data. Put a multiplier of 10 at either the Link end or Motec end. This is because Motec uses 0.1°C resolution for EGT, Link uses 1.0°C. netprosto 1 Quote Link to comment Share on other sites More sharing options...
netprosto Posted March 19, 2019 Author Report Share Posted March 19, 2019 On 3/18/2019 at 12:59 AM, Adamw said: Motec use hexidecimal notation for the CAN ID/Address, Link use decimal. Hex 384 (motec end) is decimal 900 (set at link end). Motec use the terminology "Alignment: word swap" to refer to LS byte first, so change that to normal. Uncheck the "signed" checkbox in the motec setup as you are sending from the Link unsigned data. Put a multiplier of 10 at either the Link end or Motec end. This is because Motec uses 0.1°C resolution for EGT, Link uses 1.0°C. Thank you so much! You can get me the config file of Motec C127 for Link Generic Dash or Generic Dash 2? Quote Link to comment Share on other sites More sharing options...
Adamw Posted March 20, 2019 Report Share Posted March 20, 2019 9 hours ago, netprosto said: You can get me the config file of Motec C127 for Link Generic Dash or Generic Dash 2? I have one already set up for Generic dash, I dont have one for Generic dash2. Motec Can channels (2).xlsx Link G4+ Generic Dash to Motec C127.CC8 Quote Link to comment Share on other sites More sharing options...
netprosto Posted March 20, 2019 Author Report Share Posted March 20, 2019 15 hours ago, Adamw said: I have one already set up for Generic dash, I dont have one for Generic dash2. Motec Can channels (2).xlsx 18.63 kB · 0 downloads Link G4+ Generic Dash to Motec C127.CC8 8.34 kB · 0 downloads Thank you! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.