Nikxjimenez Posted May 5, 2019 Report Share Posted May 5, 2019 Can anyone tell me how to wire my nitrous solenoid, and pressure transducer to my link g4+ pnp for a z33? And maybe any other info i may need to know to set it up properly? Please and thank you! Quote Link to comment Share on other sites More sharing options...
Adamw Posted May 5, 2019 Report Share Posted May 5, 2019 Is it wet or dry nitrous? Just on/off type or PWM? How do you want it controlled? What is the pressure sensor for? Quote Link to comment Share on other sites More sharing options...
Nikxjimenez Posted May 5, 2019 Author Report Share Posted May 5, 2019 It’s a dry shot single fogger system. Pressure sensor is for bottle pressure. I should probably mention this is my first nitrous setup. I will not be the one tuning i just need to get everything ready for the tuner. Also would assume the tuner could use the ecu as a window switch essentially. This is for a drift car so probably wouldn’t want it to be on/off. Correct me if I’m wrong! Quote Link to comment Share on other sites More sharing options...
Adamw Posted May 6, 2019 Report Share Posted May 6, 2019 The Bottle pressure sensor is usually only used to activate the bottle heater when bottle press gets to low as far as I know. Do you have a bottle heater and is that going to be ECU controlled? Quote Link to comment Share on other sites More sharing options...
Nikxjimenez Posted May 6, 2019 Author Report Share Posted May 6, 2019 Yes you are correct. Bottle heater is controlled by pressure sensor. So literally all i need is the one wire from the solenoid relay to trigger the nitrous. I see in the installation manual aux 1-16. Would one of these work as a good source? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.