Warchild Posted October 3, 2016 Report Share Posted October 3, 2016 Hi everyoneWe are about to start an install into a 2002 WRX STI Subaru (JDM). We have done MANY cars over the years, just a first for a Link system (moving brands for these cars to Link if all goes well.)So we are NOT noobies at all. So just any advice or issues we might have, someone to do before hand etc, that help would be great !LINK ECU, 3bar MAP sensor, fuel pressure and oil pressure sensors and BALLAST pack for the low impedance injectors that is part of the upgrade must be installed. many thanks ! Quote Link to comment Share on other sites More sharing options...
JMP Posted October 3, 2016 Report Share Posted October 3, 2016 add a fuel temp sensor and run the modelled fuel equation Quote Link to comment Share on other sites More sharing options...
Warchild Posted October 3, 2016 Author Report Share Posted October 3, 2016 add a fuel temp sensor and run the modelled fuel equation Hi there ! Tell me more, sounds very interesting !! Car has surge tank in the boot, so install should be easy Quote Link to comment Share on other sites More sharing options...
Scott Posted October 4, 2016 Report Share Posted October 4, 2016 The Modelled fuel mode is able to adjust the fueling based upon fuel temp (density temp coefficient). Here is a chart showing the inputs of the modelled fuel mode:PCLink Help > G4+ ECU Tuning Functions > Fuel > Fuel Setup > Fuel Equation mode contains more information.We have also have four videos on our youtube channel that talk about the differences in the fuel modes. They are pretty dry, but may be a better alternative than the PCLink help file. Let us know if you have more questions.Scott. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.