Rxm tuning

Hello , I don´t think they do this .to use your pnp ecu you can cut or remove all pin of your 350z ecu connector and solder or pin the ls engine wiring to the 350z ecu connector You will change you ecu map to of course

Yes i have done some conversion on this platform .what do you want to know about this?

Hello, here a start up map for a 4agze small port . some output and digital input will differ you need to adjust them have a nice day Monsoon 4AGZE BASE MAP.pclx

Hello, Link CAN - Lambda Sensor - can or will this replace the factory O2 sensor on the downpipe? -Yes this sensor replace the factory O2 sensor Link MAP 5 Bar Sensor - is the best install ref point on the fuel pressure regulator? -Yes Link Coolant/Oil Temp Sensor - since I have my existing Defi system, can I tap into that for ref? -you want to use it for coolant temperature or oil temp ? if its for coolant that is not necessary the oem are good Link XS Expansion Loom - Not needed you can use an volt unused for the Bosch Combined sensor (temp / pressure) with little wiring work Link KnockLink Kit - will this be best to replace / override the factory knock sensor if any? -On the pnp link g4x you have an advanced knock control you can use the factory knock sensor with the proper configuration the ecu can reduce ignition timing and add extra fuel on the cylinder he listen knock Bosch IAT sensor (with data sheets) - will figure out wiring. Bosch Combined sensor (temp / pressure) - will figure out wiring. Would it be better to run a stand alone boost controller, or would it be better to run a 4 port electronic boost controller from link? -its better to use link 4 port for a better control of your boost have a nice day

Hi i can help you email me [email protected]