Adz79

Thank you both. I spoke to Haltech this morning and they have corrected my dash config file to read correctly. They also informed me that the next IC7 update will have this corrected.

I have a G4+ PNP for my 300ZX and running a Haltech IC7 over CAN. I was using RPM/Load for gear detection and was sending the Neutral signal fine. I have now changed to a Gear Position Sensor. I have setup the gear detection correctly and the ECU is reporting P N and R. But when transmitted to the IC7 dash it’s showing allocated gear numbers 9(P) 10(R) and 11(N). Is there a way to modify the CAN stream so the IC7 will see the Letters instead of numbers? Thanks in Advance Adz

@Adamw My bad. So used to software auto updating, didn’t realize I had to install the new version. All working. Thanks

@AdamwI’m having the same problem with my G4+ 300zx plug-in. All settings are correct, all other data is streaming, just no ethanol values coming through. Both the dash and ecu state it’s all up to date. IC-7 states ICC version 1.9.8, firmware 1.5.2 hardware V2 and ecu is showing Firmware version 5.6.5.3389.