Floor It Garage

https://flooritgarage.ca/blogs/news/link-razor-pdm-decoder Thought I would share here if anyone else would find this valuable. I have installed a few Razor pdm's and am being sent back logs to review and assess, and was struggling to quickly know what outputs are active or in fault. The ECU logs the statuses of each PDM as a decimal value, derived from a binary value where each digit is a status output. So I created a Google sheet that you can take the decimal value from a log and quickly see which output is in an active state. If someone knows an easier way to do this, I'm all ears. Also hoping a version of this gets built into the G5 software in a future update.

Take a log with Flex sensor frequency and battery voltage on one of those cold start's and see what it is. 0% ethanol is 50hz from the sensor, I suspect its dropping out and the ECU is catching that

Rather then start a new thread I'll add to this one. Running 1.6.99 If I try to set a GP Logic value (a, b, c or d) back to "None" software will crash. I can do this very consistently. Work around has been to leave the GP logic value as it was and just not use it in the expression, I tried resetting just to keep it tidy. Does not inhibit function in any way. When it crashes it it wipes the file I had open. Saves the tabs but all the entered values go back to default. So I have since started saving a new file every time make a change. Tried restarting my computer, tried reinstalling the software and it still does this reliably.