jnfurniss
Members-
Posts
21 -
Joined
-
Last visited
Recent Profile Visitors
The recent visitors block is disabled and is not being shown to other users.
jnfurniss's Achievements
-
Sometimes, yes. Sometimes no. If I wiggle the cable, it'll make the sound. However, it never connects to my laptop.
-
All the sudden when I connect my laptop to my G4x I have a 350z or no longer can find my ecu. The car starts up just fine. I tried messing with the cable and nothing. Tried different ports and nothing. It was working just fine an hour before. The one thing I haven't done is unplug the cable. Where the ecu mounts, the cable comes out and is pressed against my heater core/ blower on my car. So maybe the cable or self is bad from being bent?
-
By what I have sent, are you able to see why my Lambda is pegged at 1.354.
-
changed it. https://drive.google.com/file/d/1TOroK6Xc_bDUEsPkD2XPwiI3a2F11QIl/view?usp=sharing
-
https://drive.google.com/file/d/1TOroK6Xc_bDUEsPkD2XPwiI3a2F11QIl/view?usp=sharing
-
Jack's 350z start up log.llgxJack's 350z start up log.llgx With AdamW changes2.llgx
-
Jack's 350z start up log.llgx The log is too large to share. The one I uploaded is the wrong file. Ignore that one.
-
Okay. My laptop just died so it might be tomorrow.
-
Just did everything mentioned above. Here is a new file update. With AdamW changes2.llgx Jack's 350z start up log.llgx Jack's 350z start up log.llgx
-
before you said to set it to 1% I my APS/TPS lockout to 1% as mentioned here.
-
With AdamW changes.llgx With AdamW changes2.llgx
-
jack 350z start up tune.pclx Jack's 350z start up log.llgx
-
I don't really have a tune other than the base tune that is installed on the ECU. I have adjusted the master fuel and i can get it so the car will not die. However, it still jumps from about 900rpm to 1750rpm.
-
jnfurniss started following Car won't idle steady
-
I have a 350z and I bought a G4x Xtreme. I calibrated the MAP, calibrated the TPS(which at WOT is only 95.6 %) I went in and calibrated the triggers as said on section 6.7 of the owners manual. When I turn the car on after about 3-5 seconds the idle gets very sporadic. Eventually dieing. I can hold RPMs steady and all is fine. Just curious if I missed something along the way when setting everything up.
-
So I'm rather confused at this point. My Lambda within the software is pinned at 1.302. On my wideband it's at about 14.5 which should be roughly 1 lambda. My car will idle for 5-10 seconds and then dies because the goes to about -55 MGP (kPa) of 45.9-46.3 at about 600rpm. I can hold the rpms steady around 800 and make adjustments on the mixture table, but I feel like I am missing something.