supernewbie Posted October 15, 2019 Report Posted October 15, 2019 Hi all, I've purchased my ECU and 2x XS looms to wire in the following (sparky will be doing the wiring, i'm just making sure i give him all the materials to to the job) 6x LS1 coils boost Solenoid Fuel pressure sensor After doing as much research as i can, i seem to think i have run out of aux outputs and can only choose either boost solenoid or fuel pressure. Have i missed something? Also, what is the below connector (highlighted yellow)? Listed under 'additional sensors'. Thanks in advance, Adam (from Melbourne) Quote
Richard Hill Posted October 15, 2019 Report Posted October 15, 2019 Fuel pressure is an input and will require an AnVolt, so either 5 or 6 on connector 1. Boost solenoid requires an output so Aux 6 is available on Connector 2 (assuming your PCB is rev 1.1) HTH, Richard. Quote
Adamw Posted October 16, 2019 Report Posted October 16, 2019 As Richard says, that pinout you have attached is for V1.1 which would be more than 5 years old. You likely have a V1.2 which has 2 x 8 pin connectors. V1.2 It doesnt have Aux 6 though. For boost solenoid you can use Aux 5 which is on the main ECU header, pin 19. This was originally used for the factory "fuel pressure decrease" solenoid which no one uses in performance stuff. Quote
supernewbie Posted October 16, 2019 Author Report Posted October 16, 2019 thanks all for your help!!!!! Much appreciated. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.