DriftKr6l Posted February 25, 2020 Report Share Posted February 25, 2020 Since the AIM MXS display uses CAN and I believe the G4 does not, is there still a way to hook up the display? The G4 is a Evo9 plug and play. Thanks for the help Quote Link to comment Share on other sites More sharing options...
Simon Posted February 25, 2020 Report Share Posted February 25, 2020 The G4 is able to support basic CAN. (have to run fixed can streams) Early units need hardware changes to enable it (pre 10000 serial) But it will be fine for coms to the AIM. Quote Link to comment Share on other sites More sharing options...
DriftKr6l Posted February 27, 2020 Author Report Share Posted February 27, 2020 Thanks for the info. Is there pin out info somewhere that would tell me where I can tap into the ECU with the AIM display? Quote Link to comment Share on other sites More sharing options...
Adamw Posted February 28, 2020 Report Share Posted February 28, 2020 Assuming your G4 serial number is >10000, then the easiest option is to get a CANPCB cable and a CANF plug from a link dealer. Connection is then like so: Quote Link to comment Share on other sites More sharing options...
DriftKr6l Posted February 28, 2020 Author Report Share Posted February 28, 2020 Thanks Adam, appreciate the help. Ill look at the serial number, if its 10000< then what? Would this expansion loom do the job and give me all the pinouts I need ? Or is this the correct connector so I can make my own? https://otakugarage.com.au/product/canbus-connector-kit-for-link-g4-plugin-ecu/ It would suck to have to buy two expensive cables just to get two wires out. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.