Kanjo` Posted April 25, 2020 Report Share Posted April 25, 2020 Hello everyone , I have a Honda OBD 1 PNP ECU and want to enable the Gear shift and Traction Control Feautures . I have a rotary switch for the launch control set up and I was thinking of using the same for the traction control but I have the options of 2 only maps and the use of a DI / AUX / AUX Fuel / AUX Ign options . I was thinking of using AUX Fuel#5 (AUX INj #5) and setting it up as a GP output . Does that seem correct ? Also there a way to have 3 setting instead of 2 ?Lastly the activation switch has to be wired seperately ? Like how will my rotary switch give the signal for on/off , since it has 1 input and I just connect +5V and Ground ? Also for the Gear Shift I was thinking of using the Brake switch (wire it to DI 2) so when I hit the brakes I can downshift but I am not so sure what to do with the upshift . I am not sure as well as what function to set them up either . TIA Quote Link to comment Share on other sites More sharing options...
Adamw Posted April 26, 2020 Report Share Posted April 26, 2020 18 hours ago, Kanjo` said: I have a rotary switch for the launch control set up and I was thinking of using the same for the traction control but I have the options of 2 only maps and the use of a DI / AUX / AUX Fuel / AUX Ign options . I was thinking of using AUX Fuel#5 (AUX INj #5) and setting it up as a GP output . Does that seem correct ? If you want to completely change tables then use a virtual aux. 18 hours ago, Kanjo` said: Also there a way to have 3 setting instead of 2 ? Set the table to 3D and put the rotary switch on one of the table axes. For instance: 18 hours ago, Kanjo` said: Lastly the activation switch has to be wired seperately ? Like how will my rotary switch give the signal for on/off , since it has 1 input and I just connect +5V and Ground ? Unfortunately yes, it is designed to have a switch. 18 hours ago, Kanjo` said: Also for the Gear Shift I was thinking of using the Brake switch (wire it to DI 2) so when I hit the brakes I can downshift but I am not so sure what to do with the upshift . I am not sure as well as what function to set them up either . Downshift will require either E-throttle or a blip solenoid. You might be better to connect that input to a clutch switch and use it for flat shift. Quote Link to comment Share on other sites More sharing options...
Kanjo` Posted April 26, 2020 Author Report Share Posted April 26, 2020 Thank you Adam . So make a Virtual Aux as GP Output and set the according conditions ? Do I need to wire anything to it as the schematics do not show a pin out (nnob question) ? Also I have only used all the An volt even from the expansion harness as I have Fuel Pressure an volt 4 , oil pressure an volt 5 and an volt 6 is my rotary switch for the launch control . Could it be possible the connect the an volt 6 to 2 rotary switches with different resistances or will there be a confusion (which I believe it will happen) ? Lastly , since the car is FWD should I use only the front wheels as inputs or 1 driven and 1 undriven wheel as inputs ? I have the oem abs system on the vehicle so I assume I have to connect the power from 1 abs sensor to the appropriate input , correct ? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.