MonsterMark Posted June 1, 2020 Report Share Posted June 1, 2020 I have a purchased a second hand ECU that is Mitizi evo plug-in. After contacting tech with the serial number they kindly and very promptly sent me a link to the software file.. PCLink G4+ V5.6.7.3632 once downloaded every time i try and communicate with the ECU it throws up this error message. (G4+) Error IDS not found in Data Base 1263,1264 Windows 10 home edition G4+ pc link (Options connections auto in tab is selected) ECU was stood for a few years after purchase due to family issues and building the car therefor i am unsure of the MAP or ECU status when powered it does trigger outputs for relays etc hence should be fine and is trying / booting I looked into info on the forum and i found it may be the older version software may be the key (Link). I downloaded this version and now when i try and communicate with the ECU it shows a speed of connection in the top right corner then issues a warning screen " you must use the correct manufacturers tuning software to connect to this ECU" it is therefor having some coms with the ECU i guess as more info than the (G4+) ECU software... or is it ? .... also managed to get this from the ECU Any help or guidance would be gratefully appreciated as i am trying to look at the config prior to final wiring and off to the Dyno Quote Link to comment Share on other sites More sharing options...
Adamw Posted June 1, 2020 Report Share Posted June 1, 2020 You have a either very old G4 or possibly a very old Vipec V series, cant tell without the serial number. Try this: http://www.linkecu.com/pclink/PCLink V4.4.3 Setup.exe If that doesnt work then try this old Vipec version: https://1drv.ms/u/s!AiYbYlZQuRHPmyNK85RxGVdTquXu?e=gzwd9V Quote Link to comment Share on other sites More sharing options...
MonsterMark Posted June 1, 2020 Author Report Share Posted June 1, 2020 Hi Adam Thanks so much fro your response i did send the ecu serial number to the tech team and they sent me the G4+ link i first installed . picture of ECU serial number attached to help ID Thanks again Mark 7 hours ago, Adamw said: You have a either very old G4 or possibly a very old Vipec V series, cant tell without the serial number. Try this: http://www.linkecu.com/pclink/PCLink V4.4.3 Setup.exe If that doesnt work then try this old Vipec version: https://1drv.ms/u/s!AiYbYlZQuRHPmyNK85RxGVdTquXu?e=gzwd9V serial number 6149 thanks again for your help Adam Quote Link to comment Share on other sites More sharing options...
Adamw Posted June 1, 2020 Report Share Posted June 1, 2020 Sorry I dont have a record for that serial number. However, all of the other serial numbers I have either side of that one are Vipec plug-in boards so I suspect that one is most likely a Vipec too. Try the VTS software first - it will tell you to use the correct manufacturers software when you try to connect if it is not. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.