Harry buscema Posted July 2, 2020 Report Share Posted July 2, 2020 recently bought a S14 with a forged Sr20 engine and external waste gate setup. The MAP Kpa is reaching its limit at around 4.5k rpm as shown in the log. I've check all the vacuum lines and don't see anything that would be causing a problem. just wondering if anyone would know if it was something to do with the wastegate or something with the link software? Thanks Log 2020-06-30 10;27;16 pm.llg s14 base.pclr Quote Link to comment Share on other sites More sharing options...
Rob W Posted July 2, 2020 Report Share Posted July 2, 2020 Post your tune file mate Quote Link to comment Share on other sites More sharing options...
Harry buscema Posted July 2, 2020 Author Report Share Posted July 2, 2020 2 hours ago, Rob W said: Post your tune file mate think I've done so, please let me know if that's the wrong file. thanks Quote Link to comment Share on other sites More sharing options...
Adamw Posted July 2, 2020 Report Share Posted July 2, 2020 Did it have a hi/low boost switch connected to DI6? In your tune it looks like it has been set up for two boost levels switched by DI6, but there is nothing assigned to DI6. In your log it shows DI6 was "on" which means it was using the high boost map and that high boost DC table doesnt look well set up. Quote Link to comment Share on other sites More sharing options...
Harry buscema Posted July 2, 2020 Author Report Share Posted July 2, 2020 2 minutes ago, Adamw said: Did it have a hi/low boost switch connected to DI6? In your tune it looks like it has been set up for two boost levels switched by DI6, but there is nothing assigned to DI6. In your log it shows DI6 was "on" which means it was using the high boost map and that high boost DC table doesnt look well set up. Oh wow I dident even pick up on that. Is they anyway I can manual changed it back to the low boost map? Thanks Quote Link to comment Share on other sites More sharing options...
Adamw Posted July 2, 2020 Report Share Posted July 2, 2020 Have a watch of this: https://1drv.ms/u/s!AiYbYlZQuRHPs2lkrwpgggRX9CiX?e=mfpBlD Quote Link to comment Share on other sites More sharing options...
Harry buscema Posted July 2, 2020 Author Report Share Posted July 2, 2020 5 minutes ago, Adamw said: Have a watch of this: https://1drv.ms/u/s!AiYbYlZQuRHPs2lkrwpgggRX9CiX?e=mfpBlD Wow thanks that was really helpful, understand what your talking about now. I'll give that a go and let you know how it goes. Thanks again! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.