cwhite951 Posted August 31, 2020 Report Share Posted August 31, 2020 trying to get this to work for a customer, I have it wired up on my bench to test before shipping out and I cant get the dash or hte 'live view' on the AIM softwear to display any values. Since its not connected to an engine all I was looking for is some temps and MAP values. I am not getting any. I have been through the Link and Aim set up numerous times and iust all looks good, checked the cables and they are fine. One possibility that I cant get confirmed - does the Can Bus link become active only after the engine is on line? That would explain the issue. The only other issue that I get is some Can Bus errors - but these go away if I update the link Can setting (no changes - just update it). Any thoughts? Quote Link to comment Share on other sites More sharing options...
Adamw Posted August 31, 2020 Report Share Posted August 31, 2020 Yes it will work without the engine running. Can you attach the map from the ECU, the dash config, and a couple of pics of the wiring - I realise it will only be temporary wiring but just so we can confirm correct pins are being used etc. Quote Link to comment Share on other sites More sharing options...
cwhite951 Posted September 1, 2020 Author Report Share Posted September 1, 2020 (edited) Joshua base 8-19-20 r5.pclr I do get a canbus error on the runtime values (acknowledge error, error passive & bus warning) but if i reapply the canbus settings the warnings go away until I reboot the system. No live data shown on the dash or in the AIM software. Edited May 21, 2021 by cwhite951 deleting image for space Quote Link to comment Share on other sites More sharing options...
Adamw Posted September 1, 2020 Report Share Posted September 1, 2020 Update your thunder to the latest firmware. You are on 5.6.5 which is about 3 years old. The Aim MXS CAN stream was only added into the firmware in 5.6.6 from memory. Quote Link to comment Share on other sites More sharing options...
cwhite951 Posted September 4, 2020 Author Report Share Posted September 4, 2020 On 9/1/2020 at 5:07 PM, Adamw said: Update your thunder to the latest firmware. You are on 5.6.5 which is about 3 years old. The Aim MXS CAN stream was only added into the firmware in 5.6.6 from memory. that worked perfect. I was surprised the firmware was that old, i think I had that unit on the shelf since spring. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.