Wobbly Posted September 11, 2020 Report Share Posted September 11, 2020 I have an 05 G35 Coupe.This has factory widebands installed in the headers.The car has a large number of mods done and its now time to purchase a Link, as ultimately I want to go ITB. I have a dual wideband controller , outputing 0-5V , so i can cut into the stock loom , take the stock wideband outputs from L& R banks to input the controller, and wire in the controllers two 0-5V outputs by cutting into the stock loom as well.What pin numbers do you suggest I should use to get this sensor signal into the Link. Quote Link to comment Share on other sites More sharing options...
Adamw Posted September 11, 2020 Report Share Posted September 11, 2020 Probably the most appropriate would be the orignial front Oxy sensor inputs. Pin 35 is the RF sensor signal, it is connected to Link input AN Volt 10 Pin 16 is the LF sensor signal , it is connected to Link input AN Volt 11. Quote Link to comment Share on other sites More sharing options...
Wobbly Posted September 27, 2020 Author Report Share Posted September 27, 2020 Hi Adam , I have found some more info on the Lambda setup for my 05 G35. Seems to be a difference between what you have as the Lambda signal inputs. This wiring diagram shows both pins 16 and 35 are from the RH bank 1 front Lambda. I will check next on the Lambda plugs what the wire colour codes are to try and define where I need to splice in the dual controller to the loom prior to the ECU. Unless you have already this info. Cheers Wayne Quote Link to comment Share on other sites More sharing options...
Adamw Posted September 27, 2020 Report Share Posted September 27, 2020 Connect to pin 16 & 35 as I suggested and it will work. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.