Jaye_ykh Posted September 20, 2020 Report Share Posted September 20, 2020 Hi everyone! A new comer here for some advise. Was setting up base map for a B18c on a HC96x yesterday. First start up was well on the first goal, AC request pull up resistor turned on to prevent clutch engagement to disturbing idle and trigger offset is calibrated. Thought everything is good so I left the car overnight after a few more cranks. When I get back on working the car today the car is not starting like it should the day before - settings remained unchanged and it sounded like the firing is off. So I linked the ECU with PClink to check if there are any fault codes or need to work on cold start enrichment. Fuel Pump, injectors is active when cranking; voltage is ~10V (12.2 on static). Only thing I spot out for now is AC Clutch status is faulty while cranking (please find photo attached). Could someone please give me some suggestions on the current situation? Much appreciate for the help! Kind Regards, Jaye Quote Link to comment Share on other sites More sharing options...
Adamw Posted September 20, 2020 Report Share Posted September 20, 2020 The aux out fault wont prevent it from running - that just indicates the voltage on that pin is not reaching the expected level. Try unplugging the AC clutch relay for now to see if that error goes away. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.