ben_der Posted February 10, 2021 Report Share Posted February 10, 2021 Hi guys, would like to use the Cartek XR Battery Isolator and make use of the 12V 0.5A Signal as a Ignition Kill. How would I set this up in the ECU? I reckon you would put the signal onto the Digital Input. Not sure how to configure the ECU to cut the Ignition. Any help would be appreciated. Thanks a lot! Quote Link to comment Share on other sites More sharing options...
Adamw Posted February 10, 2021 Report Share Posted February 10, 2021 Connect to any DI. Go to >Digital Inputs>Stop switch. Assign source, pull-up off, active state high Low. ECU will cut ign and fuel when that DI is high low. Edit: just read the manual and the kill output goes low when isolated, so changed my original comment above. ben_der 1 Quote Link to comment Share on other sites More sharing options...
Sterling Posted April 17, 2021 Report Share Posted April 17, 2021 Adam, How do you setup the input latch on this configuration. On or off? Thanks Quote Link to comment Share on other sites More sharing options...
Adamw Posted April 17, 2021 Report Share Posted April 17, 2021 You dont want it to latch so that should be off. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.