Adriel Posted February 16, 2021 Report Share Posted February 16, 2021 On my Link ECU, I already set the 'LR Wheel Speed' at DI 3, Link's reading accurately. To communicate Link's 'LR Wheel Speed' into the MoTeC dash, MoTeC's 'Dig In 2 Speed' channel would already be set to read Link's LR Wheel Speed. The MoTeC dash reads everything from Link accurately except for this 'LR Wheel Speed' input. On the road, cruising at 50km/h, Link's showing accurately at 50km/h, while on the MoTeC dash, it shows 5km/h only. With 80km/h, the dash only shows 8km/h, and so on. I'm not sure of what I'm doing wrong here. Please help. Quote Link to comment Share on other sites More sharing options...
Adamw Posted February 16, 2021 Report Share Posted February 16, 2021 Yeah there are a few mistakes in the default Motec template. It looks like they have the wrong divisor on that channel. In the Motec dash software, go to >Conections>communications setup, then follow the steps in the pic below to get to the DI 2 divisor, you will probably find it is set to 10, change it to 1. Quote Link to comment Share on other sites More sharing options...
Adriel Posted February 17, 2021 Author Report Share Posted February 17, 2021 You saved me once again @Adamw Thank you! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.