teedoff00 Posted March 13, 2021 Report Share Posted March 13, 2021 Hey all, I tried going through all the related threads to attempt and solve my issues but have been unable to thus far. Things I have checked or tried: Wiring. Pulled apart the dtm connectors and verified seated pins. Powertune dash is functioning normally and has readout Switched H/L pins and verified that Can Lambda is still not visible and the Powertune dash was non-functional. I am running a G4+ Link Atom II. I included pictures of the current Can Setup. Any help would be much appreciated. Thanks! CrawlerCanDiag.pclr Here is a picture of the wiring. Can Lambda is the top. Powertune is on the left, ecu is right. Quote Link to comment Share on other sites More sharing options...
Adamw Posted March 13, 2021 Report Share Posted March 13, 2021 Is this the CAN lambda pig tail shown here, or is this an extension lead that you've made yourself? The pinout doesnt appear to match the CAN lambda. Quote Link to comment Share on other sites More sharing options...
teedoff00 Posted March 13, 2021 Author Report Share Posted March 13, 2021 That is the connector that was supplied on the Can Lambda unit. Here is a better photo. The splitter was bought. I did verify that all the pins were seated per some of your other threads. Quote Link to comment Share on other sites More sharing options...
Adamw Posted March 13, 2021 Report Share Posted March 13, 2021 So why is the green wire on your splitter going to position 1 which is the red 12V wire on the Link device? Colours should match on both sides of the plug shouldnt they? Quote Link to comment Share on other sites More sharing options...
teedoff00 Posted March 13, 2021 Author Report Share Posted March 13, 2021 Well the splitter was generic. So I don't think any attention was paid to colors. The powertune dash, which are the connectors on the left; is working fine. So I'd assume the splitter would have to be working? But I'd be happy to switch any of the pins if it would help? Thank you for the help Adam! Edit* That did the trick Adam! I switched the can lambda connector to match my splitter and it's visible now. I knew it must be a simple fix, but couldn't for the life of me find it. You're a Rockstar man. Thanks again. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.