Switching fuel table and VVT table at the same time

[k fuku]

How can I switch the VVT table at the same time as the dual fuel table is switched by the digital switch?

[Adamw]

Yes, you can switch between up to 3 VVt tables, and you can use the same DI as your fuel table switch uses.

[k fuku]

Thank you very much.
Thank you for your help.

Are there any plans to update the ignition table and lambda table to allow multiple switching in the future?

[Adamw]

You can use dual ign table just like dual fuel table.  For lambda target, use the lambda target table overlay and put your switch condition on one axis.  If you truely want to switch lambda target then you would probably have to switch to multifuel mode.  

[k fuku]

 

どうもありがとうございます。

単一のデジタル入力で燃料、点火、VVT テーブルを一度に切り替えられるようにしたいと考えています。

 

CErightを使用して、テーブルを切り替えるときにテーブル1を1回点滅、テーブル2を2回点滅させたいと考えています。
これを行う良い方法はありますか?

 

[Adamw]

1 hour ago, kurosiba fuku said:

I would like to be able to switch between fuel, ignition, and VVT tables all at once with a single digital input.

You can do this already.  Example below.  Assign DI2 to each table activation, when it asks "do you want to disconnect ***" chose NO.

Once assigned you can go down to the input pins menu and change settings for pull-up etc.  You can also see what functions are assigned to a pin here.

 

 

1 hour ago, kurosiba fuku said:

I'd like to use CEright to make table 1 blink once and table 2 blink twice when switching tables.
Is there any good way to do this?

That will be a little more tricky.  I will have a closer look when I have some spare time.