Jayden1jz Posted May 2, 2021 Report Share Posted May 2, 2021 I have wired in a 2 wire ISC solenoid but I can only find stuff for 6 pin and 4 pin and can’t seem to get it to work, can somebody help me sought this out please?? Quote Link to comment Share on other sites More sharing options...
aerace_fab Posted May 2, 2021 Report Share Posted May 2, 2021 Are you Looking for frequency numbers? what style of ISCV is it? Quote Link to comment Share on other sites More sharing options...
Adamw Posted May 2, 2021 Report Share Posted May 2, 2021 Just make sure the aux output is set to "ISC Solenoid" instead of "ISC Stepper" is the only set up needed. The "Stepper motor type" setting is always visable in the ISC settings but is not used when the aux is set to solenoid. You can test the wiring/valve by setting the aux output to "Test (PWM)" and set a low frequency like 10Hz and you should hear it clicking. Normal frequency to set it to after testing would be around 150-200Hz. If still no joy then attach a log of it idling and a copy of your tune. Quote Link to comment Share on other sites More sharing options...
Jayden1jz Posted May 3, 2021 Author Report Share Posted May 3, 2021 Thanks guy got it working. It is a syltech two wire solenoid. I also put in a syltech 4bar map sensor and can’t get it to calibrate as 4 bar I had set to 3 bar gm to get it close to bap any ideas?? Quote Link to comment Share on other sites More sharing options...
Adamw Posted May 3, 2021 Report Share Posted May 3, 2021 I have never heard of Syltech, what does the datasheet give for calibration values? Quote Link to comment Share on other sites More sharing options...
Jayden1jz Posted May 3, 2021 Author Report Share Posted May 3, 2021 Thanks guy got it working. I also put in a store here 4bar map sensor and can’t get it to calibrate as 4 bar I had set to 3 bar gm to get it close to bap and ideas?? Quote Link to comment Share on other sites More sharing options...
Adamw Posted May 3, 2021 Report Share Posted May 3, 2021 Man, it really makes you doubt the quality when the sensor manufacturer quotes a MAP sensor calibration in gauge pressure... Anyhow, assuming they were at sea level on a nice day with the baro sitting at exactly 100kpa when they made up that calibration, you should set up the ecu like the pic below: koracing 1 Quote Link to comment Share on other sites More sharing options...
Jayden1jz Posted May 3, 2021 Author Report Share Posted May 3, 2021 Cheers for that. Yeah I’m not sure on the quality but a very reputable performance shop in Queensland sell them.. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.