Rms Posted June 29, 2021 Report Share Posted June 29, 2021 Hi guys .OK where do I start. OK I'm running a k20 engine with a stock harness that has been re pinned to run on my link g4+ 92-95 . Car runs fine with no issue but after getting it on duno the tuner then noticed that the ecu wasn't receiving any vvt signal. Tuner is very advanced with these systems but wasn't the person to do the wiring and now I can't get a reply from that company that did it. Has anyone done this setup before and would you think this is a simple pin error location or is there more to this . Thanks Quote Link to comment Share on other sites More sharing options...
Adamw Posted June 29, 2021 Report Share Posted June 29, 2021 The K20 needs two cam sensors connected to the ecu whereas the B/D engines only had one, so they would have had to run new wires to/from the inlet cam sensor to the ecu, most likely to DI1. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.