RH9 GTR Posted June 30, 2021 Report Share Posted June 30, 2021 Hello guys. Can any one share dead times For FIC 1100 High z. @ 43 PSi The data on FIC website does not exactly match the voltage values in Link tuning software. Quote Link to comment Share on other sites More sharing options...
Adamw Posted June 30, 2021 Report Share Posted June 30, 2021 Set the deadtime table to 3D and you can configure the axis breakpoints to match their data. Quote Link to comment Share on other sites More sharing options...
RH9 GTR Posted June 30, 2021 Author Report Share Posted June 30, 2021 Hello Adam, Can i do this without making it a 3d table. Currently no fuel pressure sensor is installed. Quote Link to comment Share on other sites More sharing options...
essb00 Posted June 30, 2021 Report Share Posted June 30, 2021 If you set it to 3D, you will be able to change the X & Y axis parameters. Put Batt Voltage on X axis, then put voltages as what's on FIC data sheet. ...then just leave Y axis parameter as 'none'. ...then enter the data. See example below. Do the same for Injector Short Pulse Width Adder Table. Quote Link to comment Share on other sites More sharing options...
RH9 GTR Posted July 1, 2021 Author Report Share Posted July 1, 2021 Aahh, great !! Never thought this way. Once again , thank you buddy. Quote Link to comment Share on other sites More sharing options...
RH9 GTR Posted July 1, 2021 Author Report Share Posted July 1, 2021 Found this data for these injectors. Are these values ok to use ? Quote Link to comment Share on other sites More sharing options...
RH9 GTR Posted July 2, 2021 Author Report Share Posted July 2, 2021 Can anyone confirm if these dead times are good to go for FIC 1100 High Z ? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.