kokkalisn Posted July 2, 2021 Report Share Posted July 2, 2021 Hello, I have a question about gear shift control. I have a 6 speed sequential geabox. The downshift is controlled by a microcontroller however I need the upshift to be controlled by the ECU in order to cut fuel or ignition and make flat shift possible. I do not have a sensor to setup gear detection with it and my only option is to set it up with the gear ratio mode. My problem is that I do not have the time to set it up using this method and I 'd like to know if gear shift control can work properly without gear detection. Thaknks! Quote Link to comment Share on other sites More sharing options...
Adamw Posted July 2, 2021 Report Share Posted July 2, 2021 It can work without gear position but you will have to run the same cut etc in all gears. You will however need something as an upshift request, usually this is a strain gauge on the shifter or a gear barrel sensor Quote Link to comment Share on other sites More sharing options...
kokkalisn Posted July 2, 2021 Author Report Share Posted July 2, 2021 All trims are the same so this is not a problem. I have DI as an upshift request. I have paddles for gear change and the DI is connected to the upshift paddle.... So I believe that I am ok with this setup. Thanks for your reply! Quote Link to comment Share on other sites More sharing options...
Adamw Posted July 2, 2021 Report Share Posted July 2, 2021 Yes should work fine then. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.