Can I create additional Calibration Tables? I'm out of linear tables.

[mattj]

Is there really only three calibration tables that can be programmed for linear sensors, or can I make additional ones?  My MAP sensor is a 4 Bar, but different from the Link 4 Bar.  I have 100psi pressure sensors and 150psi sensors.  I'm getting some lower pressure sensors for coolant and crankcase pressure, but I don't have anywhere to program them.  Only thought I have is to have to purchase sensors that are on the "supported" list, that have a "pre-programmed" table data set to them.  What are my options?

[Vaughan]

what are the calibrations of each of your sensors? I can see if any of them match up

[Adamw]

Note you can still also use cal 1-3 and 7-10 for linear cals.  Examples below for a common 100psi sensor.