TnF Posted August 23, 2021 Report Share Posted August 23, 2021 I saw this in a log file and was wondering why it's retarding 5 degrees; seems to be related to an advanced rpm/map limit option but i don't have advanced mode on on any of these two. Is it possible that it is still active in the background?! Quote Link to comment Share on other sites More sharing options...
Adamw Posted August 23, 2021 Report Share Posted August 23, 2021 With advanced mode off, all of the default limiter settings will apply. For the RPM Limit these are: Limit Control Range 200RPM End cut 100% Start cut TP 100 60% Start cut TP Low 0% Decay rate 5%/20ms Limit Ign trim -5deg Quote Link to comment Share on other sites More sharing options...
TnF Posted August 23, 2021 Author Report Share Posted August 23, 2021 15 hours ago, Adamw said: With advanced mode off, all of the default limiter settings will apply. For the RPM Limit these are: Limit Control Range 200RPM End cut 100% Start cut TP 100 60% Start cut TP Low 0% Decay rate 5%/20ms Limit Ign trim -5deg thanks a lot, this explains lots of things. Does this apply to MAP limit too? Also is this documented anywhere?! Quote Link to comment Share on other sites More sharing options...
Adamw Posted August 23, 2021 Report Share Posted August 23, 2021 You can see you existing setting by temporarily turning advanced mode on. MAP limit is the same but with a 10kpa control range. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.