mike2016 Posted September 20, 2021 Report Share Posted September 20, 2021 what's a better way to set up the charge temp table for RB26? I'm more biased towards MGP, as charge temp becomes less influenced by the surrounding heat when it's getting pressurized or there's more air flow. If in TPS mode, charge temp doesn't seem to have much of change, if any, let's say 100% TPS at 2000RPM. Quote Link to comment Share on other sites More sharing options...
Adamw Posted September 20, 2021 Report Share Posted September 20, 2021 Either should give similar results, but I would probably lean more towards TP. I find with the RB26 at low loads especially the manifold pressure doesnot represent airflow well. It is at small airflows where you generally see the biggest change in charge temp approximation. Quote Link to comment Share on other sites More sharing options...
mike2016 Posted September 20, 2021 Author Report Share Posted September 20, 2021 [img]https://i.imgur.com/bbDTMhZ.jpg[/img] Adam, is this a good starting point? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.