CAN help

[Bethanyc]

On todays episode of lockdown boredom I have broken my CAN ecu speed channel to the link display.

I had implemented this idea in the math channel thread to smooth out the speed output so it bounced around a little less on the display, while works well in the logs it seem to have killed the CAN speed output. 

i dont know anything about CAN to get that channel working again 

thanks

Beth. 

 

 

 

 

[Adamw]

The 4 speeds in AIM are the 4 wheel speeds.  So you will need a wheel speed assigned and working in the ecu.

Probably best to assign one of the wheelspeed sources to your math block output.

[Bethanyc]

thanks Adam too easy, i wasnt sure where the AIM was getting the 4 ecu speeds from and i had previously just had the gearbox signal DI4 assigned to LF. 

Sadly no actual wheel sensors in an Evo 6 RS