SeanEVO5 Posted October 9, 2021 Report Share Posted October 9, 2021 With a stock standard Mitsubishi 5 (CP9A) gear box and a Link g4x should l be able to see the gear detection in the pclink software or do l need further sensors? Quote Link to comment Share on other sites More sharing options...
Adamw Posted October 9, 2021 Report Share Posted October 9, 2021 It will work with just the standard speed sensor. Make sure you have a driving wheel speed source set up and driving wheel speed shows a realistic value when driving. Quote Link to comment Share on other sites More sharing options...
Bethanyc Posted October 9, 2021 Report Share Posted October 9, 2021 DI4, with the 260 calibration seemed to be pretty accurate at least a good starting point for speed, then as per Adam set it up as driving wheel source, then use Gear Ratio Calc runtime value as per the instructions in help file to set up the gear ratio table. I havnt played around with the new DI frequency filter yet but if it does what i think it does should provide some stability as the signal does bounce around a bit and easier to use then setting up a math block. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.