Denso Posted January 28, 2022 Report Share Posted January 28, 2022 Hello everyone I have my own car with link g4 atom Cam for m50 hall sensor Map for audi 2.5bar I start configuration trigger 1 and 2 Both i set as hall. When i crank rpm reading and suddenly give 0 After changing filter Engine running but rpm goes from 1000rpm to 4000 in fuel map I tried to change both trigger without successfully Quote Link to comment Share on other sites More sharing options...
Adamw Posted January 28, 2022 Report Share Posted January 28, 2022 Please attach a triggerscope of it cranking or running and a copy of your tune. Quote Link to comment Share on other sites More sharing options...
Denso Posted January 28, 2022 Author Report Share Posted January 28, 2022 Tomorrow i will show you Also i forget the wire signal for cam and crank still connected to stock ecu is that makes problem Quote Link to comment Share on other sites More sharing options...
Denso Posted January 29, 2022 Author Report Share Posted January 29, 2022 16 hours ago, Adamw said: Please attach a triggerscope of it cranking or running and a copy of your tune. Today i set filter to level 3 rpm problem fixed still response feel to match fuel even when i decreased table im going to change spark plug and see. The only think i can ask you is rpm in link shows 1900 to 2000 but engine shows below that 1 minute ago, Denso said: Today i set filter to level 3 rpm problem fixed still response feel to match fuel even when i decreased table im going to change spark plug and see. The only think i can ask you is rpm in link shows 1900 to 2000 but engine shows below that Sorry i have other questions about audi coils I installed wirring them give spark but i saw here someone talking about resistor is that normal Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.