Estimated Torque parameter

[SuperBCNR33]

Im looking to understand how the Estimated torque parameter calculates its value. If it's what I think it is, I would like to use it as a reference for estimating avg HP per triggered window of time. 

However, when I look at the logs this parameter always returns 0. Is there a setup needed to enable this data capture?

Also, what other parameters / sensors is it using to calculate this estimation?

Using LINK G4X - NGTRX plug in ECU on code versions: Main 6.19.60, boot 6.19.32 and board 3.1

[Adamw]

It is based on a SAE calculation "Load Absolute" - effectively air mass flow.  You need to be using modelled fuel equation for it to work correctly.

[Vaughan]

The 'Estimated Torque' runtime value uses the load parameter but you will also need to setup the Torque Management settings for it to work properly. It will still work in traditional mode but won't be as accurate.