Asimo Posted September 18, 2022 Report Share Posted September 18, 2022 Want to know which Bosch knock sensor is good for my K20 PNP, which DI input should I use? thank you Quote Link to comment Share on other sites More sharing options...
Adamw Posted September 18, 2022 Report Share Posted September 18, 2022 The stock sensor is already connected to the ecu, it will most likely work ok. Quote Link to comment Share on other sites More sharing options...
Asimo Posted September 18, 2022 Author Report Share Posted September 18, 2022 Thanks Adam , which channel I can see this on my data? Quote Link to comment Share on other sites More sharing options...
Adamw Posted September 18, 2022 Report Share Posted September 18, 2022 You have to turn knock control on and tune the knock control system. Typically you would have an experienced tuner do this, then verify with audio knock equipment that the knock control is detecting knock and only knock and is effective at suppressing the knock. You usually do this after the engine has been properly tuned. Quote Link to comment Share on other sites More sharing options...
ae82ted Posted September 27, 2022 Report Share Posted September 27, 2022 Hi Adam, I dont see any signal from the knock sensor either i input the gain to 10 or lower，7k narrow band nor any wideband sensor calibration. Any hints? Quote Link to comment Share on other sites More sharing options...
Adamw Posted September 27, 2022 Report Share Posted September 27, 2022 Attach your tune Quote Link to comment Share on other sites More sharing options...
ae82ted Posted October 1, 2022 Report Share Posted October 1, 2022 Its just the base map from the link G4X software with the knock control on and cylinder setup with knock trim table allocations. Attached for your reference. DC5Testfile.pclx Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.