Maneet Posted September 18, 2022 Report Share Posted September 18, 2022 Hi all, I have a can bus dash that currently is integrated with ecumaster using there protocol. If I where to create my own can stream CAN Setup this should help avoid me reprograming the dash side to read data correctly? I have attached a screenshot with injector pulse width as an example. Please advise. Quote Link to comment Share on other sites More sharing options...
Adamw Posted September 18, 2022 Report Share Posted September 18, 2022 Yes a multiplier of 62 would give you the same scaling as the ECU master example. Quote Link to comment Share on other sites More sharing options...
Maneet Posted September 19, 2022 Author Report Share Posted September 19, 2022 And to stream onto 0x600, 0x601, 0x602... I would declare it as the following? To screenshots would supposeldy stream to 0x600, to stream to 0x601 I would change the ID under frame to 1? Also does CAN2 on FURYX have a built in 120ohm resistor? thanks. Quote Link to comment Share on other sites More sharing options...
Adamw Posted September 19, 2022 Report Share Posted September 19, 2022 What dash do you have? It might be easier to just swap the template in the dash? With a standard CAN message you can only send one frame per Channel/ID. So 0x600 would be set up as transmit user stream 1, 0x601 transmit user stream 2 etc. In your stream set up you need to change the frame ID position to none. This frame ID is only used for compound/mutliplexed messages where you sen a bunch of frames all on the same CAN ID. But otherwise the rest of your stream setup looks good. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.