FIS Posted February 10, 2023 Report Share Posted February 10, 2023 Please help with PDM problem, The PDM works fine in few weeks, today it suddenly dies when I was setting the ECU idle and E Throttle. The problem happened when I switched ignition off and on again but failed, all output LED status were off only temperature LED status goes on red. I touched to check the body it feels normal warm. Then I connect laptop with ignition off (powered USB) to see the status, LED temperature status goes on red, connection status was connected but none of status information appeared including PDM status. PDM configuration I have made also blank. With ignition on also same. Quote Link to comment Share on other sites More sharing options...
Adamw Posted February 10, 2023 Report Share Posted February 10, 2023 If its not doing the LED dance on power up then that really does sound like it is dead. Very odd. Contact [email protected] to discuss. Quote Link to comment Share on other sites More sharing options...
Darrow Posted August 27, 2023 Report Share Posted August 27, 2023 Same just happened to me. Setting parameters on my furyX and cycling the ignition key to test the fuel pump prime parameter. Now the Razor just has a solid red light. I cannot find anything to help with the troubleshooting. Quote Link to comment Share on other sites More sharing options...
Adamw Posted August 28, 2023 Report Share Posted August 28, 2023 I think you might have a brick. Contact [email protected]. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.