khalil Posted May 13, 2023 Report Share Posted May 13, 2023 good day trying to confirgue a link thunder ecu to a motec SDL via can H and can L I Have tried all wire configirations with and without 120ohm resisters but cant seem to connect the two iv attached my base map and dash config file please help base map bat.pclr SDL-Dash-Link(1).U16 Quote Link to comment Share on other sites More sharing options...
Adamw Posted May 13, 2023 Report Share Posted May 13, 2023 What CAN port is it wired to on the ECU? You have a dash set up on both CAN 1 and CAN2? Quote Link to comment Share on other sites More sharing options...
khalil Posted May 14, 2023 Author Report Share Posted May 14, 2023 Wired to can 1 Quote Link to comment Share on other sites More sharing options...
Adamw Posted May 14, 2023 Report Share Posted May 14, 2023 Try these base map bat V2.pclr SDL Generic Dash.U16 Quote Link to comment Share on other sites More sharing options...
khalil Posted May 14, 2023 Author Report Share Posted May 14, 2023 hi adam no luck with those files please find the fault codes currently displayed when testing on both can 1 and can 2 Quote Link to comment Share on other sites More sharing options...
Adamw Posted May 14, 2023 Report Share Posted May 14, 2023 You most likely have a wiring issue then, I tested both files on the bench with a Thunder and my old ADL. Quote Link to comment Share on other sites More sharing options...
khalil Posted May 14, 2023 Author Report Share Posted May 14, 2023 Only 2 wires for can tho? Iv tried swapping them around can H and Can L and even moved them to Can 2 but same story Any idea what I could have done wrong? Quote Link to comment Share on other sites More sharing options...
Adamw Posted May 15, 2023 Report Share Posted May 15, 2023 If you unplug the connector from the back of the dash and with ignition on, measure the voltage between pin 4 & 36 and 4 & 35, what voltages do you have there? Quote Link to comment Share on other sites More sharing options...
khalil Posted May 16, 2023 Author Report Share Posted May 16, 2023 V2.43 on both pin 35 and 36 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.