noahbid Posted May 17, 2023 Report Share Posted May 17, 2023 I’ve got Link G4x xtreme and am trying to setup the can lambda but it won’t show a reading. Doing everything in the instructions but no luck. Do I need an ohm resistor with this setup???? Quote Link to comment Share on other sites More sharing options...
koracing Posted May 17, 2023 Report Share Posted May 17, 2023 Can you post a copy of your tune with the CAN settings? Also just to check, you have verified you have good 12v switched power and a good ground source going to the CAN Lambda unit? Under CAN settings have you tried to detect devices on that can bus? The Link CAN Lambda has an option to run when stalled or not, and you can use that to see if it powers up and gives a reading without starting the motor, otherwise it's set to not turn on until it sees the engine running. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.