efi265 Posted June 25, 2023 Report Share Posted June 25, 2023 hi guys i have dual tables for fuel,ignition and boost .i am wondering if theirs away to tell which map its running off .hmm thin i just worked it out .Is the blend table tell you so if its 100% its table 2 solely ?..i don't seem to be getting anymore boost it seems to be at the dc1 map limit ?is it using maps ? do i just need more duty Cycle perhaps ? i was worried because my ic7 kept coming up over-boost but that was set to 15 psi .so up that its a stock motor and i want to push 20psi on the e85. OK so next question >i have setup speed sensors and have configured slip control which i am sorting but i seen that theirs gear detection and have just tried setting that up .i have speed and rpm axis and ecu calculated .how do i go about making this work i drove in 1st gear and it picked it up then what do i do .i have set it too 4 gears .i tried to go thru them all but after the 1st gear i turned if off and it went from 1st to neutral .so i tried to do the other gears and i went to second then neutral.i have and old valiant 4 speed .and gear detection would be mean as it shows up on my ic7 .just need to configure it .thanks attached is a log and pcl https://1drv.ms/u/s!AsueBbAiWzmW2BdySnUB04VLX_m8?e=5f9ZOM https://1drv.ms/u/s!AsueBbAiWzmW2BjlcSald_wGkGjH?e=u7oQo9 , Quote Link to comment Share on other sites More sharing options...
Adamw Posted June 26, 2023 Report Share Posted June 26, 2023 100% in the blend table means its using 100% of table 2. Your log shows the correct duty cycle is being commanded. For the gear detection there are instructions in the help file for the automated calibration. The other option is just log a drive around the block through all gears then enter the recorded ratio for each gear in user defined mode. Your attached log doesnt have much data for 1st or 2nd gear to be confident I have it right but it looks like it would probably be something like this: Quote Link to comment Share on other sites More sharing options...
efi265 Posted June 26, 2023 Author Report Share Posted June 26, 2023 awesome i found another post on how to sort it thanks . so ill try it thank you Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.