Dano.Mano Posted August 18, 2023 Report Share Posted August 18, 2023 I have a G4+ running ethrottle, I did the board modification. I had a G4x top board and swapped them over. Trying to setup ethrottle, I think the error I got was something about no h bridge. the information available says the 4x plugins have ethrottle but need a board mod. I assumed the mod was to the bottom board. is there also something needs doing to the top board to enable ethrottle or am I just having a brain fart and missing a setting somewhere? Quote Link to comment Share on other sites More sharing options...
Adamw Posted August 18, 2023 Report Share Posted August 18, 2023 Can you attach a log and the tune. There is no difference in terms of bottom board requirements. Did Link modify the board? Quote Link to comment Share on other sites More sharing options...
danamaniac Posted August 19, 2023 Report Share Posted August 19, 2023 Can i use a virtual aux for the ethrottle relay as i did with g4+. I cant seem to do the same in the g4x. Quote Link to comment Share on other sites More sharing options...
danamaniac Posted August 19, 2023 Report Share Posted August 19, 2023 Here is config. Please note i do not have a relay connected to aux8. When i calibrate tps, it moves the throttle plate so h bridge is getting power. Throttle plate does not move, it only moves during a tps calibration. Do i need to install a power relay onto pin 35 of the bottom board? in g4+ i just set a virtual aux? Any way to make this a virtual relay on here. Would like to avoid relay install if possible. r33.pclx Quote Link to comment Share on other sites More sharing options...
Adamw Posted August 19, 2023 Report Share Posted August 19, 2023 I think Aux 9 active state set to low will be the main problem. You also had some pretty crazy idle settings so I have made a few changes. Try this map. If still no throttle then please attach a log. r33 DBW fix.pclx Quote Link to comment Share on other sites More sharing options...
Dano.Mano Posted August 19, 2023 Author Report Share Posted August 19, 2023 Thanks, I have not yet started the car to setup the idle that is why. Quote Link to comment Share on other sites More sharing options...
danamaniac Posted August 20, 2023 Report Share Posted August 20, 2023 Hi Adam, Throttle is working, but stays at 30% percent open and wont close any further. Log and config attached. r33ts.llgx r33ts.pclx Quote Link to comment Share on other sites More sharing options...
Adamw Posted August 20, 2023 Report Share Posted August 20, 2023 23 hours ago, Adamw said: You also had some pretty crazy idle settings so I have made a few changes. It doesnt look like you used the map I done with all the idle stuff fixed. Quote Link to comment Share on other sites More sharing options...
danamaniac Posted August 20, 2023 Report Share Posted August 20, 2023 Uploaded your map, throttle plate just smashed at 100%. Will upload your map again and change to active low so throttle plate dont go crazy. see how it goes. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.