r33lew Posted August 19, 2023 Report Share Posted August 19, 2023 Im currently using a Linx tablet through PCLink as a dash whilst i wait for the new MXT aim dash. So i know the original cluster takes the speed signal from the gearbox and sends it to the ECU, but without the cluster. How can i get that information to the ECU? Quote Link to comment Share on other sites More sharing options...
Adamw Posted August 20, 2023 Report Share Posted August 20, 2023 You can likely wire the sensor direct to a DI, it will depend how much voltage the sensor can generate but I expect it would be ok. Quote Link to comment Share on other sites More sharing options...
r33lew Posted August 20, 2023 Author Report Share Posted August 20, 2023 Yeah 12 minutes ago, Adamw said: You can likely wire the sensor direct to a DI, it will depend how much voltage the sensor can generate but I expect it would be ok. Yeah, so ive found that it is just a 2 wire sensor, one for sensor ground and one for DI, the bit im left with, is how will i configure this in the ECU? Thanks for your respons Adam Quote Link to comment Share on other sites More sharing options...
Adamw Posted August 20, 2023 Report Share Posted August 20, 2023 Digital inputs>GP Input>GP Speed. Set the source that it is wired to, set the calibration so the speed reads correct. Quote Link to comment Share on other sites More sharing options...
Vaughan Posted August 20, 2023 Report Share Posted August 20, 2023 I use a calibration of 530 for my Stagea with the gearbox speed signal wired direct to the ECU, yours will be different but that should get you in the ballpark Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.