briand.vq35 Posted August 21, 2023 Report Share Posted August 21, 2023 Does anyone know what the data cable connector is called? I’m just looking to make some cabling of my own for experimental purposes. Quote Link to comment Share on other sites More sharing options...
Adamw Posted August 21, 2023 Report Share Posted August 21, 2023 Do you mean the 6 pin CAN/USB connector? It is a LTW Ceres mini series. Quote Link to comment Share on other sites More sharing options...
briand.vq35 Posted August 27, 2023 Author Report Share Posted August 27, 2023 On 8/21/2023 at 5:07 AM, Adamw said: Do you mean the 6 pin CAN/USB connector? It is a LTW Ceres mini series. That’s what I was talking about. Thank you. Am I correct in assuming this tuning port is also where I would wire in my CAN Lambda? Quote Link to comment Share on other sites More sharing options...
Adamw Posted August 27, 2023 Report Share Posted August 27, 2023 No, CAN bus socket is inside the case on the 350Z ecu. Quote Link to comment Share on other sites More sharing options...
briand.vq35 Posted August 28, 2023 Author Report Share Posted August 28, 2023 Forgive me; I’m new. At the risk of sounding completely ignorant; would I need to take the front cover off to complete the install of the CAN Lambda? If so; any advice on removal? I started an attempt before joining here, but feared I was going to break it. This is mainly my reasoning behind making more cables. Quote Link to comment Share on other sites More sharing options...
Adamw Posted August 28, 2023 Report Share Posted August 28, 2023 Yes, remove the base first, there is a screw that needs to be removed - marked 16 in the pic below. With that screw out the whole board and main connector should lift out of the top cover. Be careful as there is the coms cable and a vacuum hose attached, you can tilt it up towards the back to access those. Quote Link to comment Share on other sites More sharing options...
briand.vq35 Posted September 6, 2023 Author Report Share Posted September 6, 2023 Thanks for the help. Got everything sorted in this regard. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.