Ming Posted August 30, 2023 Report Share Posted August 30, 2023 hello i also need help setting up the AEM CD7 dash for fuel level link to the ecu. what setup can i use ? thanks Quote Link to comment Share on other sites More sharing options...
koracing Posted August 30, 2023 Report Share Posted August 30, 2023 You'll need a variable resistance level sender (like most OEM sensors), a 5v supply, and the signal from the sender with a pullup-resistor to 5v (usually much lower than most temp sensor pullups) on it feeding into an analog input on the ecu. It should be possible to set up a custom stream to send this information to the CD7 dash once you're reading it and have it calbrated in the ecu. Quote Link to comment Share on other sites More sharing options...
Ming Posted August 31, 2023 Author Report Share Posted August 31, 2023 21 hours ago, koracing said: You'll need a variable resistance level sender (like most OEM sensors), a 5v supply, and the signal from the sender with a pullup-resistor to 5v (usually much lower than most temp sensor pullups) on it feeding into an analog input on the ecu. It should be possible to set up a custom stream to send this information to the CD7 dash once you're reading it and have it calbrated in the ecu. Thanks bro I'll try this out. Quote Link to comment Share on other sites More sharing options...
Ming Posted September 4, 2023 Author Report Share Posted September 4, 2023 On 8/31/2023 at 12:26 AM, koracing said: You'll need a variable resistance level sender (like most OEM sensors), a 5v supply, and the signal from the sender with a pullup-resistor to 5v (usually much lower than most temp sensor pullups) on it feeding into an analog input on the ecu. It should be possible to set up a custom stream to send this information to the CD7 dash once you're reading it and have it calbrated in the ecu. I've done with wiring but im not sure how to setup the can setup in the AEM software. Quote Link to comment Share on other sites More sharing options...
Adamw Posted September 4, 2023 Report Share Posted September 4, 2023 Attach your tune and dash config. Quote Link to comment Share on other sites More sharing options...
Ming Posted September 8, 2023 Author Report Share Posted September 8, 2023 On 9/4/2023 at 8:16 PM, Adamw said: Attach your tune and dash config. here's the setup Quote Link to comment Share on other sites More sharing options...
Adamw Posted September 8, 2023 Report Share Posted September 8, 2023 Try these. Rafi tuned by HM3.pclx Rafi2 Custom3.aemcd7 Quote Link to comment Share on other sites More sharing options...
Ming Posted September 9, 2023 Author Report Share Posted September 9, 2023 21 hours ago, Adamw said: Try these. Rafi tuned by HM3.pclx 468.15 kB · 0 downloads Rafi2 Custom3.aemcd7 4.28 MB · 0 downloads thanks will try this out Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.