Looking for advice on turbo onset improvements - closed loop PID control

[byront8]

Hi there - attaching a log and my tuning file  just looking for some advice if there is anyway to improve the turbo spool speed on this setup? Its set into closed loop and the logs only show its goes into stage2-3 really late, and my WG DC% is 100% (even with a 14psi spring).

Logs look like I never reach stage3 PID control, just stage1 and 2, and I never reach boost target. I'm wondering if i start this at a lower activation point (say 100kpa vs 110kpa), and if I need to adjust the P, I, and D to get me there

Any help greatly appreciated

PC Datalog - 2023-12-16 8;49;30 am.llgx TTFile.pclx

[Adamw]

If it cant reach boost target with the wastegate at 100%DC then that would suggest a mechanical or plumbing issue.  With the gate at 100% the boost should shoot straight past the target until you hit the MAP limiter.