Steven100 Posted February 4 Report Share Posted February 4 Is there anyone that has the knowledge or know if I can or can’t wire the 2 wires on the Mac valve to the link expansion loom and which outputs they go to. Same color black wires on the Mac valve so I’m assuming it doesn’t matter which wire goes to which as long as they get connected. All of this on a jzx100 pnp. Quote Link to comment Share on other sites More sharing options...
JMP Posted February 4 Report Share Posted February 4 Feed one wire on the mac valve with ignition switched 12V, then connect the other wire to one of your spare Aux out's Steven100 1 Quote Link to comment Share on other sites More sharing options...
Steven100 Posted February 4 Author Report Share Posted February 4 I still don’t know which wires to connect to on either of the expansion slots. Quote Link to comment Share on other sites More sharing options...
JMP Posted February 4 Report Share Posted February 4 I'd wire it to INJ8 Steven100 1 Quote Link to comment Share on other sites More sharing options...
koracing Posted February 7 Report Share Posted February 7 INJ8, IGN4, IGN5, IGN6 would all work, but the XSL1 connector with INJ8 has more options to wire in additional sensors (like a fuel pressure sensor). Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.