Bosch knock sensors rb26 wiring + syltech combo sensor questions

[MichaelR32GTR]

Hey guys

 

im in the middle of doing some upgrades, getting rid of the factory 1 wire knock sensors and wiring up some Bosch 2 wire knock sensors,

am I right in wiring them this way (using tefzel twin core shielded cable)

knock sensor end - knock sensor signal wire and ground to each sensor 

 

ecu end - knock sensor 1 and 2 signal wire to dedicated knock sensor pins

Then knock sensor grounds + shields all twisted together to sensor ground ?

 

also I just installed a Syltech oil temp/pressure sensor, is there an existing calibration table that works with them ?

 

thanks !

[Adamw]

 

For the combo sensor, use the STD bosch NTC for the temp input and cal 4/5/6 as below for the pressure input.  

[MichaelR32GTR]

Perfect Thankyou