MichaelR32GTR Posted February 19 Report Share Posted February 19 Hey guys im in the middle of doing some upgrades, getting rid of the factory 1 wire knock sensors and wiring up some Bosch 2 wire knock sensors, am I right in wiring them this way (using tefzel twin core shielded cable) knock sensor end - knock sensor signal wire and ground to each sensor ecu end - knock sensor 1 and 2 signal wire to dedicated knock sensor pins Then knock sensor grounds + shields all twisted together to sensor ground ? also I just installed a Syltech oil temp/pressure sensor, is there an existing calibration table that works with them ? thanks ! Quote Link to comment Share on other sites More sharing options...
Adamw Posted February 20 Report Share Posted February 20 For the combo sensor, use the STD bosch NTC for the temp input and cal 4/5/6 as below for the pressure input. Quote Link to comment Share on other sites More sharing options...
MichaelR32GTR Posted February 20 Author Report Share Posted February 20 Perfect Thankyou Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.