Mathew lloyd Posted February 25 Report Share Posted February 25 Currently wiring a G4 thunder with AIM pdm32 and AIM key pad. Currently have the basics setup from Link ecu to aim pdm. But I need to add extra outputs to the pdm for control. Electric fan, Fuel pump, two stage no2, No2 Purge, No2 bottle heater, Attessa pump on/off, Attessa Solenoid, additional 6 AN voltage inputs for Egt temps. Shifter position. Happy to set it up my end if they’re a bit of a write up to follow to doing it. Just looking to pin map on the bench before committing to the sealed harness. regards Mathew Quote Link to comment Share on other sites More sharing options...
Adamw Posted February 25 Report Share Posted February 25 Im happy to help set up the CAN side once you have the IO planned out and a list of what needs to be done. Note G4+ cant send PWM signals via CAN so anything that requires PWM you will either need to use a hardwired output from ecu to PDM or just send the required control signals to the PDM and do all the control logic in the PDM. Mathew lloyd 1 Quote Link to comment Share on other sites More sharing options...
Mathew lloyd Posted February 26 Author Report Share Posted February 26 Great News Thanks Adam. So, I've attached My Configs from the Pdm and G4 Thunder. I Used one of your previous examples on the forums for the thunder and aim pdm32. I put the additional channels in a word document. Appreciate the help mate. TRAVIS R32 WIRING.docx Travis R32 Radial Car.pclr PDM32 Travis R32 Radial Car 1.zconfig Quote Link to comment Share on other sites More sharing options...
Mathew lloyd Posted March 25 Author Report Share Posted March 25 @Adamw Gday Adam, were you able have a look at these? Thanks mate. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.