MichaelR32GTR Posted May 12 Report Share Posted May 12 Hi ive added more sensors and made changes along the way using link g4+ Fury Can I confirm that when using these Bosch temp/pressure sensors they need the following calibration to work: -Temperature connected to AN Temp, use the “std Bosch NTC” calibration -Pressure connected to AN Volt, using CAL4 can make a table with input value A - 0.50v inout value B - 4.50v output units - kpa output value A - 0kpa output value B - 1000kpa will this work accurately ? Or should I put values A and B as slightly lower values outside of the 0.5 - 4.5v range ? need to setup for optimal accurate reading thanks Boosted4g63 1 Quote Link to comment Share on other sites More sharing options...
Adamw Posted May 12 Report Share Posted May 12 As you have it written is exactly how it should be set. Boosted4g63, quad_cam_magna and MichaelR32GTR 3 Quote Link to comment Share on other sites More sharing options...
MichaelR32GTR Posted May 29 Author Report Share Posted May 29 Just one more question, musing the above calibration in CAL 4 for my combined oil pressure sensor does it matter is you use CAL 1-3, or 4-6, or 7-10 ? Quote Link to comment Share on other sites More sharing options...
Adamw Posted May 29 Report Share Posted May 29 Cal 4/5/6 are the easiest for linear sensors in G4+, Cal 1-3 are aimed more at temp sensors so the axis breakpoints are less flexible. Cal 7-10 have user-assignable axes breakpoints so they can be used for anything. Boosted4g63 and MichaelR32GTR 2 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.