team claymore Posted June 5 Report Share Posted June 5 Hi i have read through everything i could see relative to my issue and made changes but still need some assistance. I can get throttle to move when doing tps calibration but thats the only time it will move. im using a bosch throttle body 82mm and bosch pedal # 0280 755 051. New to using link so i may need instructions on how to send you the file for you to look at it. i also have a list of pin location see below: an volt 5 pedal 1 an volt 6 pedal 2 an volt 7 tps main an volt 11 tps sub I had the ecu sent off for ethrottle upgrade, i have also done a firmware upgrade too. Link Clazzo.pclx Quote Link to comment Share on other sites More sharing options...
Adamw Posted June 5 Report Share Posted June 5 Your E-throttle target table should have APS on one axis, you currently have TPS. Quote Link to comment Share on other sites More sharing options...
team claymore Posted June 6 Author Report Share Posted June 6 16 hours ago, Adamw said: Your E-throttle target table should have APS on one axis, you currently have TPS. I see thank you. Where do I change this setting? Quote Link to comment Share on other sites More sharing options...
Vaughan Posted June 6 Report Share Posted June 6 right click on the table, Axis Setup. Or select table and press the X key. team claymore 1 Quote Link to comment Share on other sites More sharing options...
team claymore Posted June 6 Author Report Share Posted June 6 all sorted !! thank you Vaughan 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.