neil brown Posted July 28, 2014 Report Share Posted July 28, 2014 plugged in the can cable to the g4 storm and cable to link display which i had overhaulled at christchurch not that long ago  when i try to connect it says this ecu might not be can enabled ? please check serial number as hardware might need updated  as serial numbers under 10,000 not enabled, got serial number 4739  does the ecu need returned for a mod to run the link display or can i change settings to rx/tx instead of can h and can l Quote Link to comment Share on other sites More sharing options...
Simon Posted July 28, 2014 Report Share Posted July 28, 2014 If you set the dash to Link G4 for the ECU type and lower the ECU Baud rate to 57600 you will be able to get it working over serial. Quote Link to comment Share on other sites More sharing options...
neil brown Posted July 28, 2014 Author Report Share Posted July 28, 2014 got it working,  been trying to connect to ecu via the pc and have the display connectiong at same time  so basically its either pc or display cant support both at same time Quote Link to comment Share on other sites More sharing options...
Simon Posted July 29, 2014 Report Share Posted July 29, 2014 Correct, the CAN upgrade will allow both to be connected at the same time. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.