Brad Scheigis Posted November 15, 2011 Report Share Posted November 15, 2011 Hey guys We have what would appear to be a V3 or V4 here that we are wanting to run a two wire idle up solenoid on. Have wired to Aux 1 and +12v and now need to fit the diode on the board. However checking the hand controller I can see no where to program the ISV, is there a trick to this?? Brad Quote Link to comment Share on other sites More sharing options...
Simon Posted November 16, 2011 Report Share Posted November 16, 2011 Hi Brad. On the hand control if you hold down one of the edit or adjust keys whilst on the Engine RPM it should give you a software ID some thing like D42Vxxx can you get back to me with this code. Failing this working it should also be on a sticker on the main micro. (lid will need to be removed) Quote Link to comment Share on other sites More sharing options...
Simon Posted January 12, 2012 Report Share Posted January 12, 2012 What you have is a antilag equipped ecu this comes at the cost of ISC in this case. Quote Link to comment Share on other sites More sharing options...
Simon Posted January 30, 2012 Report Share Posted January 30, 2012 A V5 upgrade and a retune would be required. We would need to see the ECU back. [email protected] will be able to sort the finer details. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.