vnm02 Posted December 1, 2011 Report Share Posted December 1, 2011 Hi Guys, I have a quick question in relation to the internal map sensor on the storm, Is it 4kpa or 2.5 because there is no selection for the 4.0 in the software?? Â I am having trouble calibrating the internal map, as it keeps saying that it is either <5kpa or >5kpa and can not be calibrated. Â I have the smae engine running the same ECU just older and the two map pressures are different the old ECU is set to 2.5kpa. Any ideas???? Â Thanks Quote Link to comment Share on other sites More sharing options...
vnm02 Posted December 1, 2011 Author Report Share Posted December 1, 2011 Previously Bruce Ross wrote: Hi Guys,  I am having trouble calibrating the internal map sensor, as it keeps saying that it is either <5kpa or >5kpa and can not be calibrated. Any ideas????  Thanks  Quote Link to comment Share on other sites More sharing options...
Jurgen Biggelaar Posted December 2, 2011 Report Share Posted December 2, 2011 Hi Bruce. The Storm has a 2.5bar MAP sensor (1.5bar positive), so will read up to about 22psi (150Kpa). Make sure you only have 1 x MAP sensor selected in the set up or it will have issues. If you have another wired in for some other reason, this must be selected as a GP Input on your an volt channel. Be sure the MAP sensor in the program is selected as MAP 2.5bar, and as a test you could either measure the output wire (white) at the MAP sensor, or look at the voltage on that AN channel using your runtimes (F12). At rest, as in key on and no engine running it should be reading approximately 1.8v (100Kpa). Let us know how you get on. Jurgen Quote Link to comment Share on other sites More sharing options...
Chris Young Posted December 7, 2011 Report Share Posted December 7, 2011 Are the Bosch 5 bar type okay to use? i have a 1St gen g4 Storm and i want to use more than 30PSI? Sorry to thread hijack. Quote Link to comment Share on other sites More sharing options...
Simon Posted December 8, 2011 Report Share Posted December 8, 2011 Bosch 5 bar can be used but will most likely require the use of a cal table. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.